Removal Procedure
WARNING: This page is about a different car, the 2020 GMC Terrain and 2020 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
- Prepare the control module for removal using the SPS programming support tool. K47 Rear Differential Clutch Control Module: Programming and Setup
- Raise and support the vehicle. Lifting and Jacking the Vehicle
Remove the control module bracket bolt (1).
Remove the control module bracket bolts (1).
Remove the four control module bolts (1).
Remove the control module brackets (1).
Disconnect the connectors from the control module.
- Remove Wiring Harness Retainer from Clutch Control Module.
Remove the clutch control module (1) by rotating it 180 degrees and sliding it out of the passenger side area above the axle shaft.
NOTE:
The rear differential clutch control module can now be removed and replaced.