FixVault
Home › GMC › 2023 › Canyon AT4 › Repair and Diagnosis › Steering › Steering Column › Steering Wheel And Column › Repair Instructions › Turn Signal Switch Replacement › Removal Procedure

Removal Procedure

  1. Extend the steering column to its furthest point to allow the instrument panel steering column upper trim cover to clear the instrument panel.
  2. GM6148245Courtesy of GENERAL MOTORS COMPANY

    Using a small plastic trim tool, separate the instrument panel steering column upper trim cover (1) from the instrument panel steering column lower trim cover.

  3. Instrument Panel Steering Column Upper Trim Cover (1) - Remove
  4. GM6153160Courtesy of GENERAL MOTORS COMPANY

    Turn the steering wheel approximately 90 degrees to the left of the centered position.

  5. Instrument Panel Steering Column Lower Trim Cover Bolt (1) - Remove
  6. GM6153158Courtesy of GENERAL MOTORS COMPANY

    Turn the steering wheel approximately 90 degrees to the right of the centered position.

  7. Instrument Panel Steering Column Lower Trim Cover Bolt (1) - Remove
  8. GM6153157Courtesy of GENERAL MOTORS COMPANY

    Turn the steering wheel to the centered position.

  9. Instrument Panel Steering Column Lower Trim Cover Bolt (1) - Remove
  10. GM6148344Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Maneuver the instrument panel steering column lower trim cover around the steering column tilt and telescoping lever as necessary.

    Instrument Panel Steering Column Lower Trim Cover (1) - Reposition

  11. GM6148244Courtesy of GENERAL MOTORS COMPANY

    Turn Signal Switch Bolt (1) - Remove [2x]

  12. Disconnect the electrical connector. (3)
  13. GM6148343Courtesy of GENERAL MOTORS COMPANY

    Turn Signal Switch (1) - Remove

About FixVault