Replace and Program Control Module or Reprogram Control Module
WARNING: This page is about a different car, the 2024 Chevrolet Silverado 3500 HD and 2024 Chevrolet Silverado 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
To program a replacement or an existing control module, perform the following procedure:
- Ignition/Vehicle OFF
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, under Select Controller, select K4 Assist Step Control Module.
- On the SPS Supported Controllers screen, under Select Function / Sequence, select Programming and follow the on-screen instructions.
- On the SPS Supported Controllers screen, under Select Function / Sequence, select Setup and follow the on-screen instructions.
- At the end of programming, choose the "Clear DTCs" function on the SPS screen.