Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

WARNING:
When removing, handling or installing this component wear protective gloves. The sharp edges on the component may be very sharp and may cause injury.

Instrument Panel Knee Bolster Bolt (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
Instrument Panel Knee Bolster (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clips.
Pull away from the front side door weatherstrip to remove the left instrument panel outer trim cover (1).
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Carrier Bolt (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
Instrument Panel Trim Plate Applique (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Switch Trim Plate Bolt (1) - Remove [5x]
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clips.
Reposition the component to access the electrical connector.
Disconnect the electrical connectors.
Instrument Panel Switch Trim Plate - Left Side (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using a suitable plastic trim tool, release the retaining tabs.
Trailer Brake Control Switch (1) - Remove