Programming an Existing or New Control Module

Ignition - On / Vehicle - In Service Mode
Perform one of the following SPS Programming functions:
NOTE:
If both controller options below are listed, select K20/K71 Engine and Transmission Control Modules.
- K20/K71 Engine and Transmission Control Modules and follow the on-screen instructions.
- K71 Transmission Control Module and follow on-screen instructions.
1. Select - Programming
2. Select - MCVM Operations - If applicable
3. Ignition/Vehicle - Off - For greater than 2 min
4. Select - Setup - Follow the on-screen instructions.
Clear DTCs after programming is complete. Clearing powertrain DTCs will set the Inspection/Maintenance (I/M) system status indicators to No.
Perform the scan tool configuration/reset function: Transmission Service Fast Learn - If available
All OK.