FixVault
Home › Genesis › 2017 › G80 3.8, AWD › Repair and Diagnosis › External Pages › Different variant/trim › Section 16 (Starting System - 5.0L) › Starter › Repair Procedures › Disassembly

Repair Procedures: Disassembly

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the M-terminal on the magnet switch assembly.
    G11335333
  2. After loosening the 3 screws (A), detach the magnet switch assembly (B).
    G11335334
  3. Loosen the through bolts (A).
    G11335335
  4. Remove the brush holder assembly (A), yoke (B) and armature (C).
    G11335336
  5. Remove the shield (A).
    G11335337
  6. Remove the lever plate (A) and lever packing (B).
    G11335338
  7. Disconnect the planet gear (A).
    G11335339
  8. Disconnect the planet shaft assembly (A) and lever (B).
    G11335340
  9. Press the stop ring (A) using a socket (B).
    G11335341
  10. After removing the stopper (A) using stopper pliers (B).
    G11335342
  11. Disconnect the stop ring (A), overrunning clutch (B), internal gear (C) and planet shaft (D).
    G11335343
  12. Reassembly is the reverse of disassembly.
NOTE: Using a suitable pulling tool (A), pull the overrunning clutch stop ring (B) over the stopper (C).
G11335344
About FixVault