FixVault
Home › Genesis › 2017 › G80 3.8, AWD › Repair and Diagnosis › Restraints › Air Bag, SRS › Supplemental Restraint System Control Module & Sensors › Occupant Classification System (OCS) › Repair Procedures › Installation › OCS Ecu

OCS Ecu

  1. Install the OCS ECU on the Front seat track assembly.
  2. Connect the OCS ECU connector.
  3. Install the front passenger seat assembly.

    (Refer to Body - "FRONT SEAT ")

  4. Reconnect the battery negative cable.
  5. After installing the OCS, confirm proper system operation:
    • Turn the ignition switch ON the SRS indicator should be turned on for about six seconds and then go off.
    • Telltale lamp will turn on for 4 seconds and be turned off for 3 seconds. After the 7 seconds, it shall remain off if the OCS does not require suppression and the passenger airbag is enabled.
    NOTE: Be sure to perform OCS reset with GDS after replacing OCS equipped seat cushion.
About FixVault