FixVault
Home › Genesis › 2017 › G80 3.8, RWD › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Control System - 3.8L › Engine Coolant Temperature Sensor (ECTS) › Repair Procedures › Removal

Repair Procedures: Removal

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Remove the air cleaner assembly.

    (Refer to INTAKE & EXHAUST SYSTEM - 3.8L Engine Mechanical System )

  3. Disconnect the engine coolant temperature sensor connector (A).
  4. Remove the water temperature sensor from the water temperature control assembly.
    CAUTION:
    • Note that engine coolant may leak out of the water temperature control assembly when removing the sensor.
G11355020Courtesy of
About FixVault