Repair Procedures: Removal

WARNING: This page is about a different car, the 2016 Kia Sedona. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: lf replacement of the bracket of BSD unit is required, it is recommended to surely replace the defective part only with a new one, not the whole BSD unit.

Disconnect the negative (-) battery terminal.
CAUTION: Be careful when removing the blind spot detection unit. The bracket may break off from the bumper.
Remove the rear bumper.
(Refer to Body - "REAR BUMPER COVER ")
Disconnect the BSD connector (A) from the BSD unit.

Fig 1: Locating BSD Connector From BSD Unit
Courtesy of KIA MOTORS AMERICA, INC.
Remove the BSD assembly (A) after loosening the mounting nuts.
Tightening torque: 8.8 - 13.7 N.m (0.9 - 1.4 kgf.m, 6.5 - 10.1 lb.ft)

NOTE: Be careful not to damage the bracket when removing the BSD unit.

Fig 2: Removing BSD Assembly Mounting Nuts
Courtesy of KIA MOTORS AMERICA, INC.

Information

If the bracket is physically deformed or damaged, replace the extension wire or bracket.
- Remove the bracket (A) from the BSD unit by loosening the screws.
Fig 3: Locating Bracket Screws
Courtesy of KIA MOTORS AMERICA, INC.