FixVault
Home › Genesis › 2017 › G90 5.0 Ultimate, AWD › Repair and Diagnosis › External Pages › Different car › Section 85 (Engine Control System - 3.8L) › Injector › Repair Procedures › Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2017 Genesis G80. However, it is still accessible from the selected car via links, so may be relevant.
G11355084Courtesy of
  1. Combustion seal
  2. Rubber washer
  3. Support disc
  4. O-ring
CAUTION:
  • Do not reuse the used injector fixing clip.
CAUTION:
  • Install the component with the specified torques.
  • Note that internal damage may occur if the component drops. In this case, use it after inspection.
CAUTION:
  • Apply engine oil to the injector O-ring.
  • Do not reuse the used injector O-ring.
CAUTION:
  • Do not reuse the used bolt.
CAUTION:
  • When inserting the injector, be careful not to damage the injector tip.
CAUTION:
  • Do not reuse the support disc.
  • Do not reuse the injector rubber washer.
  • When replacing the rubber washer, the rounded edge (A) should face the cylinder installation and the angulated edge (B) should face the injector body.
G11355085Courtesy of
CAUTION:
  • Do not reuse the combustion seal.
  1. To install, reverse the removal procedure.
About FixVault