Repair Procedures: Replacement
CAUTION:
- Put on gloves to prevent hand injuries.
NOTE:
- When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
- When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
- Take care not to bend or scratch the trim and panels.
- Remove the front seat assembly.
(Refer to Front Seat - "FRONT SEAT ASSEMBLY ")
- Remove the front seat rear shield outer cover.
(Refer to Front Seat - "FRONT SEAT SHIELD OUTER COVER ")
- Remove the front seat headrest (A) by pulling it upward.
- Remove the front seat lower protector (A).
- Remove the front seat back board (A).NOTE:
- Grasp the both lower sides of back board with hands and then remove it in the direction of the arrow.
- Be careful not to damage the fixing clips.
- Remove the front seat air ventilation seat back duct (A).
- Remove the protector (A) from the front seat back frame.
- Using a screwdriver or remover, remove the front seat headrest guides (A) by pulling them upwards.NOTE: * How To Remove The Headrest Guide
- Twist the headrest guide to pull it out.
CAUTION:- Be careful not to damage the steel clip (B).
- Remove the front seat back cover (A) from the front seat back frame.
- After removing the velcro tape (A) and hog-ring clips (B) on the front of seat back and remove the front seat back cover (C).CAUTION:
- Make sure that the sponge insert wire is not dislocated.
- Install in the reverse order of removal.
Information
- Make sure that the connectors are connected completely
- Replace any damaged clips.
- To prevent wrinkles, make sure that the cover (B) is stretched evenly before connecting the hog-ring clips (A).
- Replace the hog-ring clips with new ones using special tool (C) (09880-4F000).