FixVault
Home › Genesis › 2018 › G80 3.8, AWD › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Control System - 3.8L › Crankshaft Position Sensor (CKPS) › Repair Procedures › Removal

Repair Procedures: Removal

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the crankshaft position sensor connector (A).
  3. Remove the installation bolt (B), and then vertically remove the sensor from the transaxle housing.
    G12657616Courtesy of HYUNDAI MOTOR AMERICA
About FixVault