Repair Procedures: Installation

CAUTION: Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.

Install a new front impact sensor.
Tighten the front impact sensor mounting nut.
Tightening torque:

7.8 - 11.7 N.m (0.8 - 1.2 kgf.m, 5.7 - 8.6 lb-ft)
Connect the front impact sensor connector.
Install the radiator assembly.
Reconnect the battery negative cable.
After installing the front impact sensor, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off.