FixVault
Home › Genesis › 2019 › G80 3.8, AWD › Repair and Diagnosis › Engine Performance › Fuel Delivery › Fuel Delivery System - 3.8L › Fuel Line › Repair Procedures › Removal › [Front Fuel Line]

[Front Fuel Line]

  1. Release the Residual Pressure In Fuel Line.

    (Refer to Fuel Delivery System - "RELEASE RESIDUAL PRESSURE IN FUEL LINE ")

  2. Turn the ignition switch OFF and disconnect the negative (-) battery terminal.
  3. Disconnect the fuel feed tube quick-connector (A).
  4. Disconnect the vapor hose (B) which is connected from the PCSV.
    G12657797Courtesy of HYUNDAI MOTOR AMERICA
    NOTE:
    • Open the clamp cover (B) before disconnecting the quick connector. (If the clip is applied)
      G12657798Courtesy of HYUNDAI MOTOR AMERICA
    CAUTION:
    • When removing the quick-connector with the clip removing tool (A), be careful not to damage the plastic clip (B).
    • If the clip is damaged, the fuel line leak can occur due to poor connection.
      G12657799Courtesy of HYUNDAI MOTOR AMERICA
  5. Lift the vehicle.
  6. Remove the front-left wheel & tire and wheel house cover.
  7. Remove the front-left side under cover (A).
    G12657800Courtesy of HYUNDAI MOTOR AMERICA
  8. Remove the fuel line protector (A) after removing mounting nuts.
    G12657801Courtesy of HYUNDAI MOTOR AMERICA
  9. Disconnect the front vapor and fuel tube line quick-connector (A).
    G12657802Courtesy of HYUNDAI MOTOR AMERICA
  10. Remove the front vapor and fuel feed tube bracket (A).
    G12657803Courtesy of HYUNDAI MOTOR AMERICA
  11. Remove the noise barrier (A) after loosening the mounting bolt and nut.
  12. Remove the front vapor and fuel tube line (B).
    G12657804Courtesy of HYUNDAI MOTOR AMERICA
    G12657805Courtesy of HYUNDAI MOTOR AMERICA
About FixVault