FixVault
Home › Genesis › 2019 › G80 3.8, AWD › Repair and Diagnosis › Engine Performance › System › Engine Control System Diagnosis - 3.8L (3 Of 3) › DTC U0109: Lost Communication With Fuel Pump Control Module › Wiring Inspection › Signal Circuit Inspection › Open Check

Open Check

  1. IG "OFF".
  2. Disconnect FPCM and PCM (ECM) connector.
  3. Measure resistance between P-CAN HIGH terminal (LOW terminal) of the FPCM harness connector and P-CAN HIGH terminal (LOW terminal) of the PCM (ECM) harness connector.

    Specification:  Approx. below 1Ω

  4. Is the measured value within specifications?

    YES 

    NO 

    • Repair open in P-CAN BUS line between FPCM harness connector and PCM (ECM) harness connector and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
About FixVault