Repair Procedures: Inspection

WARNING: This page is about a different car, the 2017 Genesis G90. However, it is still accessible from the selected car via links, so may be relevant.

Turn the ignition switch OFF.
Disconnect the console temperature, mode, ON/OFF actuator connector.

Verify that the console temperature control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 7.

Verify that the console actuator operates to the vent mode when connected in reverse.

Fig 1: Checking Console Temperature Control Actuator Operation

Courtesy of HYUNDAI MOTOR AMERICA

[Console Temperature Actuator]

Pin NO	Function
1	-
2	-
3	Cool position
4	Sensor (+5V)
5	Feedback signal
6	Sensor ground
7	Warm position

[Console Mode Actuator]

Pin NO	Function
1	-
2	-
3	Rear vent
4	Sensor (+5V)
5	Feedback signal
6	Sensor ground
7	Rear floor

[Console ON/OFF Actuator]

Pin NO	Function
1	-
2	-
3	Console (ON)
4	Sensor (+5V)
5	Feedback signal
6	Sensor ground
7	Console (OFF)

Connect the console temperature, mode, ON/OFF actuator connector.
Turn the ignition switch ON.
Check the voltage between terminal 5 and 6.
If the measured voltage is not within specification, check the operation by replacing the existing console temperature, mode, ON/OFF actuator with a new genuine part. After that, determine whether replacement of the temperature control actuator is required or not.