[Without ECS]
- Turn ignition switch OFF and disconnect the negative (-) battery cable.
- Remove the front wheel and tire (A) from the front hub.
Tightening Torque:
107.9 - 127.5 N.m (11.0 - 13.0 kgf.m, 79.6 - 94.0 lb-ft)
NOTE:- Be careful not to damage the hub bolts when removing the front wheel and tire.
- Remove the wheel speed sensor connector (A). [2WD]
- Remove the wheel speed sensor bracket bolt from the knuckle. [2WD]
Tightening torque:
6.9 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.1 - 8.0 lb-ft)
- Remove the wheel speed sensor and cable bracket from the knuckle. [AWD]
Tightening torque:
6.9 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.1 - 8.0 lb-ft)
- Remove the front wheel guard.
(Refer to Body - "FRONT WHEEL GUARD ")
- Remove the cable bracket by loosening the mounting bolts (A) & (B).
Tightening torque:
6.9 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.1 - 8.0 lb-ft)
(B): 8.8 - 13.7 N.m (0.9 - 1.4 kgf.m, 6.5 - 10.1 lb-ft)
[2WD]
[AWD]
- Remove the clip and then separate the connector (A).
[2WD]
[AWD]
- Install in the reverse order of removal.