Verification Of Vehicle Repair
WARNING: This page is about a different car, the 2022 Genesis G90. However, it is still accessible from the selected car via links, so may be relevant.
After a repair, it is essential to verify that the fault has been corrected.
- Connect GDS and check "No. of Key learnt, ECM status and Smartkey ECM status".
- Select "Diagnostic Trouble Codes (DTC) " mode and then clear DTC.
- Operate the vehicle within the enable condition and monitor the DTC on the GDS.
- Are any DTCs present?
YES
- Go to the applicable troubleshooting procedure.
NO
- System is performing to specification at this time.