Repair Procedures: Installation
WARNING: This page is about a different car, the 2022 Genesis G90. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.
- Install the new front impact sensor.
- Connect the front impact sensor connector.
- Install the front impact sensor mounting bolt.
Tightening torque:
7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)
- Reconnect the battery negative cable.
- After installing the Front Impact Sensor, confirm proper system operation:
- Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.