FixVault
Home › Genesis › 2021 › GV80 3.5T Advanced › Repair and Diagnosis › Restraints › Air Bag, SRS › Airbag Modules And Clock Spring › Curtain Airbag (CAB) Module › Repair Procedures › Installation

Repair Procedures: Installation

  1. Disconnect the negative (-) battery terminal.
    WARNING:
    • Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
  2. Tighten the curtain airbag mounting bolts.

    Bolts: 7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)

    Nuts: 3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 lb-ft)

    CAUTION:
    • Never twist the airbag module when installing it. If the module is twisted, the airbag module may operate abnormally.
  3. Connect the curtain airbag connector.
  4. Install the roof trim assembly.

    (Refer to Body (Interior and Exterior) - "ROOF TRIM ASSEMBLY ")

  5. Reconnect the negative (-) battery terminal.
  6. After installing the curtain airbag (CAB), confirm proper system operation.
    NOTE:
    • Turn the ignition switch ON; the SRS indicator light should turn on for about 6 seconds and then go off.
About FixVault