ECM Neutral Mode procedure (With Immobilizer)
WARNING: This page is about a different variant/trim than selected.
- After replacing the ECM of the vehicle with the immobilizer, the following procedure must be performed.
[If installing a used ECM]
- Perform "ECM Neutral Mode" procedure using diagnostic tool.
(Refer to Body Electrical System - "Immobilizer System")
- After finishing "ECM Neutral Mode", perform "Key Teaching" procedure using diagnostic tool.
(Refer to Body Electrical System - "Immobilizer System")
[If installing a new ECM]
- Perform "Key Teaching" procedure using diagnostic tool.
(Refer to Body Electrical System - "Immobilizer System")