FixVault
Home › Genesis › 2023 › G80 2.5T Advanced, AWD › Repair and Diagnosis › External Pages › Different car › Section 108 (Heater System) › Console Temperature Control Actuator › Repair Procedures › Inspection

Repair Procedures: Inspection

WARNING: This page is about a different car, the 2024 Genesis G80. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch OFF.
  2. Disconnect the console temperature control actuator and console ON/OFF actuator connector.
  3. Verify that the console temperature actuator and console ON/OFF actuator operates to the cool position when connecting 12V to terminal 7 and grounding terminal 3. Verify that the temperature control actuator operates to the warm position when connected in reverse.
    G15555127Courtesy of HYUNDAI MOTOR AMERICA

    [Console temperature control actuator] 

    1. -
    2. -
    3. Warm position 4. Sensor ground
    4. Sensor ground
    5. Feedback signal
    6. Sensor power (+5V)
    7. Cool position (Console OFF)

    [Console temperature control (A) actuator] 

    1. -
    2. -
    3. Warm position
    4. Sensor ground
    5. Feedback signal
    6. Sensor power (+5V)
    7. Cool position (Console OFF)

    [Console ON/OFF actuator] 

    1. -
    2. -
    3. Console (OFF)
    4. Sensor ground
    5. Feedback signal
    6. Sensor power (+5V)
    7. Console (ON)
  4. Connect the console temperature control actuator and console ON/OFF actuator, console mode connector.
  5. Turn the ignition switch ON.
  6. Check the voltage between terminal 4 and 5
  7. If the measured voltage is not within specification, substitute with a known-good console temperature actuator and console ON/OFF actuator and then check for proper operation.
About FixVault