FixVault
Home › Genesis › 2023 › G80 2.5T Advanced, AWD › Repair and Diagnosis › External Pages › Different car › Section 18 (Engine Control System - 2.5L) › Engine Control Module (ECM) › Repair Procedures › Adjustment › [When installing an ECM with learning experience]

[When installing an ECM with learning experience]

WARNING: This page is about a different car, the 2024 Genesis G80. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform "ECM Neutral Mode" procedure with diagnostic tool.

    (Refer to Body Electrical System - "IMMOBILIZER SYSTEM ")

  2. After finishing "ECM Neutral Mode", perform "Key teaching" procedure with diagnostic tool.

    (Refer to Body Electrical System - "IMMOBILIZER SYSTEM ")



  1. Perform "ECM Neutral Mode" procedure with diagnostic tool.

    (Refer to Body Electrical System - "SMART KEY ")

  2. After finishing "ECM Neutral Mode", Use a key (or press the start button) and turn it to the IGN ON and OFF position. Then the ECM learns the smart key information automatically.

    (Refer to Body Electrical System - "SMART KEY ")

About FixVault