System Operation

FCA: Forward Collision-avoidance Assist)

Basic specification (front camera applied)

Courtesy of HYUNDAI MOTOR AMERICA

The time indicated will be changed according to vehicle speeds.

Step 1: Issue a visual (display) and vocal alarm when a danger is detected.
Step 2: Reduce engine torque and activates FCA when there is a high chance of collision.
Step 3: Activate emergency brake when a collision is imminent.
After stopping the vehicle: Maintain the braking control for a certain time and then release it.

Information

Braking power is adjusted depending on the risk levels of collision, but it is released immediately when it detects the driver's action to avoid a collision.

When it exceeded the maximum operation speed.
When it detected driver's action to avoid a collision such as sudden steering changes.
When the shift lever is in R or P
When you pressed the accelerator pedal half way.

CAUTION:

When you drive at 85 km/h - 160 km/h or faster, the system does not go to step 2 of emergency braking.
- Full auto braking is not available.
When you drive at 85 km/h or faster, the system does not go to step 3 of emergency braking.
- But a collision may occur at depending on the road conditions.
- Partial braking may be applied according to the surrounding environment.
- For the vehicle parked in front, full braking is applied at level 3 after the warning only when the vehicle speed is under 75 km/h. Up to level 2 is performed when the vehicle speed is over 75 km/h.
- For the pedestrian and cyclists, full braking is applied at level 3 after the warning only when the vehicle speed is under 65 km/h.
  Up to level 1 is performed when the vehicle speed is over 65 km/h.
Offset should be less than 50%.
FCA does not work on the vehicles backing up or resisting.

Information

Offset: Rate of non-overlapping on the line between the front driving car and my car

Offset 0%:

Courtesy of HYUNDAI MOTOR AMERICA

Courtesy of HYUNDAI MOTOR AMERICA

SCC: Smart Cruise Control