FixVault
Home › Geo › 1992 › Tracker Base, RWD › Repair and Diagnosis › Electrical › Starter - Reduction Gear › On-Vehicle Testing › Ignition Switch Test › Metro

Ignition Switch Test: Metro

  1. Using test light, backprobe White/Green wire terminal of ignition switch 5-terminal connector. Connector is located on right of junction block, under left dash panel. Test light should glow.
  2. If test light does not glow, check fusible links "A" and "B". Fusible link box is located behind battery. Check for open in White/Green wiring circuit to ignition switch. See appropriate chassis wiring diagram in the WIRING DIAGRAMS section.
  3. Turn ignition switch to START position. Using a test light, backprobe Black/Yellow wire terminal (at ignition switch 9-terminal connector) to starter circuit and Black/Blue wire terminal to ignition power circuit. Test light should glow. If test light does not glow at either terminal, replace ignition switch.
About FixVault