Wipers Operate; Wiper Switch Turned Off
Unplug junction block connector C8 (located behind left kick panel). See Fig 1 . Turn ignition on. If wipers stop, replace wiper motor. If wipers do not stop, check for short circuit to voltage in Blue/Red wire between combination switch and wiper motor. If wire is okay, replace combination switch.
JUNCTION BLOCK CONNECTOR C8 TERMINAL ID
| Cavity | Wire Color | Circuit |
|---|---|---|
| 1 | WHT/RED | HAZ Fuse Horn Relay |
| 2 | Not Used | Not Used |
| 3 | BLU/GRN | Horn Switch/Horn Relay |
| 4 | GRN/YEL | RH Front Turn Lamp |
| 5 | PPL/YEL | ECM Diagnostic Request Signal |
| 6 | YEL | Back Fuse |
| 7 | RED | Headlights |
| 8 | YEL/BLU | WIP Fuse/Front Wiper Motor |
| 9 | GRN/RED | LH Front Turn Lamp |
| 10 | WHT | TAIL Fuse |
| 11 | Not Used | Not Used |
| 12 | RED/WHT | Headlamps |
| 13 | RED/YEL | Light Switch |
| 14 | Not Used | Not Used |