Washer Pump Does Not Operate
- Turn ignition switch to ON position. Using test light, backprobe between washer pump connector terminal No. 2 (Blue wire) and ground. If test light illuminates, go to next step. If test light does not illuminate, check for open in Blue wire between junction block No. 1 Black 16-pin connector terminal No. 2 and washer pump motor. See Fig 1
. See JUNCTION BLOCK 10-PIN CONNECTOR TERMINAL IDENTIFICATION table. If wire is okay, replace junction block No. 1. Junction block is located behind left kick panel. Washer pump motor is located under washer reservoir.
- Using a fused jumper wire, backprobe between washer pump side of combination switch Black 20-pin connector terminal No. 8 (Blue/Yellow wire) and ground. If washer pump operates, go to next step. If washer pump does not operate, check for open in Blue/Yellow wire between washer pump and combination switch. If wire is okay, replace washer pump.
- Using a test light, backprobe between junction connector No. 1 White 6-pin connector terminal No. 3 (White/Black wire) and battery voltage. Junction connector No. 1 is located under center of instrument panel. If test light illuminates, check for open in White/Black wire. If wire is okay, replace combination switch. If test light does not illuminate, check for open in White/Black wire between junction connector No. 1 and ground. If wire is okay, replace junction connector No. 1.
Courtesy of GENERAL MOTORS CORP. JUNCTION BLOCK 10-PIN CONNECTOR TERMINAL ID
| Terminal No. (Wire Color) |
Circuit |
| 1 (GRN/BLK) |
Left Front Turn Light |
| 2 (BLU) |
WIP (20-Amp) Fuse |
| 7 (BLK) |
Starter Relay/Starter Solenoid |
| 8 (WHT/BLK) |
Ground |
| 9 (BLU/YEL) |
DOME (15-Amp) Fuse |
| 10 (GRN) |
(Headlights/Low Beams) |
| 12 (RED/YEL) |
Headlights/High Beam |
| 12 (WHT/BLK) |
Ground |
| 13 (BLK/ORG) |
Ignition Switch |
| 14 (BLK/RED) |
AM2 (30-Amp) Fusible Link/Ignition Switch |
| 15 (BLK/ORG) |
IGN (10-Amp) Fuse |
| 16 (GRN/YEL) |
Right Front Turn Light |