FixVault
Home › Honda › 1982 › Prelude Automatic Trans › Repair and Diagnosis › Engine Performance › Ignition System › TOYO DENSO Electronic Ignition - HONDA › Overhaul › Disassembly

TOYO DENSO Electronic Ignition - HONDA: Overhaul: Disassembly

  1. Remove spark plug wires and vacuum hoses from distributor. Remove distributor cap. Remove condenser ground wire and disconnect pick-up coil wire connector from distributor. Remove hold-down bolt, lifting distributor from cylinder head.
  2. Carefully pry upward on reluctor with 2 screwdrivers, cushioned with rags to prevent damage to distributor housing. Use care not to damage reluctor or stator.
  3. Remove advance diaphragm mounting screw. Pull out on diaphragm unit, while pushing down on end of diaphragm arm.
  4. Drive roll pin from distributor shaft. Remove shaft and gear from housing. Inspect and replace parts as necessary.
About FixVault