Forced Starting of Display

Special Tools Required:  SCS service connector 07PAZ-0010100

1. Locate the navigation service check connector (A) under the front passenger's seat.
   Fig 1: Locating Navigation Service Check Connector

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Connect the SCS service connector (B) to the navigation service check connector (A).
3. Check that the diagnosis menu for the picture diagnosis starts up, and then changes to the system link menu.
4. If the display does not turn on, turn the ignition switch OFF, press and hold the SET UP button (A), press and hold the joystick (B) up, then turn ignition switch to ACC (I).
   NOTE: If the display fails to light or the system link screen is not displayed, refer to no picture is shown on the display (see No picture is shown on the display  ).
   Fig 2: Pressing & Holding SET UP Button

   Courtesy of AMERICAN HONDA MOTOR CO., INC.