FixVault
Home › Honda › 2000 › Prelude Base, Automatic › Repair and Diagnosis (Single Page) › Body & Frame › Door Locks › Door Locks & Trunk Release - Power › Programming › Storing Transmitter Code

Storing Transmitter Code

NOTE: Procedures must be performed within the stated time limits between steps. Up to 3 transmitters may be coded into system.
  1. Turn ignition on. Within 4 seconds, press transmitter LOCK/UNLOCK button with remote transmitter aimed/pointed at keyless entry receiver unit. See COMPONENT LOCATIONS  . Within 4 seconds, turn ignition off. Repeat procedure twice, then go to next step.
  2. Turn ignition on. Within 4 seconds, press transmitter LOCK/UNLOCK button with remote transmitter aimed/pointed at keyless entry unit. Confirm door lock actuators are operating, then go to next step.
  3. Within 10 seconds, aim the first transmitter at vehicle and press transmitter LOCK/UNLOCK button. Confirm door lock actuators are operating. Repeat procedure (within 10 second interval) for the other transmitters. Up to 3 remote transmitters can be programmed/coded. After programming/coding transmitters, go to next step.
  4. Turn ignition off. Remove key from ignition switch. Aim each transmitter at vehicle and press transmitter LOCK/UNLOCK button. Confirm door locks operate with each transmitter code. If remote transmitters do not lock or unlock doors, repeat step  1 .
About FixVault