Set/Resume/Cancel Switch Test/Replacement

Remove the two screws (A), then remove the switch (B).

Fig 1: Identifying Set/Resume/Cancel Switch 4P Connector Terminals
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for continuity between the terminals in switch position according to the table.
- If there is continuity and it matches the table, but switch failure is occurred on the cruise control unit input test, check and repair the wire harness on the switch circuit.
- If there is no continuity in one or both positions, replace the switch.
  
  Fig 2: Set/Resume/Cancel Switch Test Table
  Courtesy of AMERICAN HONDA MOTOR CO., INC.