FixVault
Home › Honda › 2002 › Civic Si › Repair and Diagnosis › External Pages › Different car › Section 15 (Wheel Alignment Specifications & Procedures) › Wheel Alignment Procedures › Toe-In Adjustment › Rear

Toe-In Adjustment: Rear

WARNING: This page is about a different car, the 2005 Honda Civic, 2004 Honda Civic, and 2003 Honda Civic. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure parking brake is released to avoid an incorrect measurement. Check toe-in. See WHEEL ALIGNMENT SPECIFICATIONS  . If no adjustment is required, remove alignment equipment. If adjustment is required, go to next step.
  2. Hold adjusting bolt on rear lower control arm and loosen lock nut. Adjust rear toe-in by turning adjusting bolt until toe-in is correct. See WHEEL ALIGNMENT SPECIFICATIONS  . Install NEW lock nut, and tighten it while holding adjusting bolt. See Fig 1 and TORQUE SPECIFICATIONS  . Recheck toe-in.
Fig 1: Adjusting Rear Toe-In
G00040634Courtesy of AMERICAN HONDA MOTOR CO., INC.
About FixVault