FixVault
Home › Honda › 2004 › Odyssey EX › Repair and Diagnosis › External Pages › Different car › Section 60 (Keyless/Power Door Locks/Security System) › CESS Articulated Harness Replacement

CESS Articulated Harness Replacement

WARNING: This page is about a different car, the 2006 Honda Odyssey and 2005 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the sliding door panel (see SLIDING DOOR PANEL REMOVAL/INSTALLATION ), and rear side trim panel (see TRIM REMOVAL/INSTALLATION - REAR SIDE AREA ).
  2. Disconnect the 16P and 8P connectors (A) from the sliding door wire harness.

    With power sliding door

    Fig 1: Disconnecting 16P And 8P Connectors From Floor Wire Harness
    G03706660Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Disconnect the 16P and 8P connectors (B) from the floor wire harness.
  4. Remove the two screws, clip and bolt, then remove the CESS articulated harness (C).
  5. Install in the reverse order of removal.
About FixVault