ABS Modulator-Control Unit Removal and Installation: Installation
- Install the ABS modulator-control unit, then tighten the two 8 mm nuts.
- Align the connecting surface of the ABS control unit 31P connector.
- Push in the lock of the ABS control unit 31P connector until you hear it click into place.
- Connect the six brake lines.
- Bleed the brake system, starting with the front wheels.
- Connect the HDS, and do the solenoid function test for each wheel.
- Bleed the brake system again, starting with the front wheels.
- Start the engine, and check that the ABS indicator and brake system indicator go off.
- Disconnect the HDS. Test-drive the vehicle, and check that the ABS indicator and brake system indicator do not come on.