FixVault
Home › Honda › 2006 › Civic Si › Repair and Diagnosis › Engine Performance › System › PGM-FI System (K20Z3 Engine) › ECT Sensor 2 Replacement

ECT Sensor 2 Replacement

  1. Drain the engine coolant (see COOLANT REPLACEMENT ).
  2. Remove the splash shield; 2-door (see FRONT SPLASH SHIELD REPLACEMENT ), 4-door (see FRONT SPLASH SHIELD REPLACEMENT ).
  3. Disconnect the ECT sensor 2 2P connector (A), then remove ECT sensor 2 (B).
    Fig 1: Identifying ECT Sensor 2 2P Connector And ECT Sensor 2
    G06273284Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Install parts in the reverse order of removal with a new O-ring (C).
  5. Install the splash shield; 2-door (see FRONT SPLASH SHIELD REPLACEMENT ), 4-door (see FRONT SPLASH SHIELD REPLACEMENT ).
  6. Refill the radiator with engine coolant (see COOLANT REPLACEMENT ).
About FixVault