2000-05 Models

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2009 Honda S2000, 2008 Honda S2000, 2007 Honda S2000, 2006 Honda S2000, and 2005 Honda S2000. However, it is still accessible from the selected car via links, so may be relevant.

SRS components are located in this area, review the SRS component locations, 2000-05 models (see COMPONENT LOCATION INDEX ), 2006-08 model (see PRECAUTIONS AND PROCEDURES ), precautions, and procedures (see PRECAUTIONS AND PROCEDURES ), before performing repairs or service.

Remove the knee bolster under the steering column.
Disconnect the 14P connector from the cruise control unit.
Inspect the connector and connector terminals to be sure they are making good contact.
If the terminals are bent, loose, or corroded, repair them as necessary, and recheck the system.
Do the following input test, at the 14P connector.
- If a test indicates a problem, find and correct the cause, then recheck the system.
- If all the tests prove OK, check the cruise control actuator operation, and adjust the actuator cable.
  
  Fig 1: Identifying Cruise Control Unit Input Test Chart
  Courtesy of AMERICAN HONDA MOTOR CO., INC.
If any test indicates a problem, find and correct the cause, then recheck the system. If all the input tests prove OK, the control unit may be faulty. Substitute a known-good cruise control unit, and reset. If the system works properly, replace the cruise control unit.