DTC 65: Brake Fluid Level
- Check the brake fluid level in the master cylinder reservoir.
Is brake fluid level OK?
YES - Go to step 22.
NO - Inspect the brake pads: Front (see FRONT BRAKE PAD INSPECTION AND REPLACEMENT ), Rear (see REAR BRAKE PAD INSPECTION AND REPLACEMENT ), and replace worn out brake pads, then recheck.
- Turn the ignition switch ON (II).
- Clear the DTC with the HDS.
- Turn the ignition switch to LOCK (0).
- Disconnect the brake fluid level switch 2P connector.
- Turn the ignition switch to ON (II).
- Check for DTCs with the HDS.
Is DTC 65 indicated?
YES - Go to step 8.
NO - Replace the reservoir (brake fluid level switch is included) on the master cylinder (see MASTER CYLINDER INSPECTION ).
- Turn the ignition switch to LOCK (0).
- Disconnect the gauge control module 36P connector.
- Check for continuity between brake fluid level switch 2P connector terminal No. 2 and body ground.
Is there continuity?
YES - Repair short to body ground in the wire between the gauge control module and the brake fluid level switch.
NO - Check for loose terminals in the VSA modulator-control unit 47P connector. If necessary, substitute a known-good VSA modulator-control unit (see VSA MODULATOR-CONTROL UNIT REMOVAL AND INSTALLATION ), and retest.