FixVault
Home › Honda › 2007 › Element SC, Standard › Repair and Diagnosis › Body & Frame › Exterior/Interior Trim › Exterior Trim › Front Fender Cladding Replacement › '07-08 Models

'07-08 Models

NOTE:
  • Put on gloves to protect your hands.
  • Take care not to scratch the body.
  1. From the wheel arch, remove the screws (A, B) and clips (C).
    Fig 1: Identifying Wheel Arch, Screws & Clips
    G05451187Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Open the door. From outside the door, remove the upper and middle clips, and from inside the door, remove the lower clip securing the front fender cladding and front fender.
    Fig 2: Identifying Front Fender Cladding & Front Fender Clips
    G05451188Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Pull out along the upper edge on the front fender cladding (A) to release clips, then remove the cladding from the body. LX, EX, models: Disconnect the front turn signal light connector (B).
    Fig 3: Identifying Front Fender Cladding & Front Turn Signal Light Connector
    G05451189Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Install the cladding in the reverse order of removal, and note these items:
    • When removing the remaining clips from the body, turn the clip 90°, and pull it out.
    • Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
    • Make sure the front turn signal light connector is plugged in properly.
    • Push the clip portions into place securely.
About FixVault