Rear Power Window Motor Test

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Honda Crosstour, 2014 Honda Crosstour, 2013 Honda Crosstour, 2012 Honda Crosstour, and 2011 Honda Accord Crosstour. However, it is still accessible from the selected car via links, so may be relevant.

Remove the rear power window switch (see REAR POWER WINDOW SWITCH TEST/REPLACEMENT ).
Test the motor in each direction by connecting battery power and ground to the rear power window switch 14P connector (A) according to the table.

Fig 1: Rear Power Window Switch 14P Connector Terminals Chart
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Fig 2: Identifying Rear Power Window Switch 14P Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the motor does not run or fails to run smoothly, go to next step.
Remove the door panel (see REAR DOOR PANEL REMOVAL/INSTALLATION ).
Disconnect the 2P connector (A) from the rear power window motor (B).

Fig 3: Identifying Rear Power Window Motor 2P Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Check for continuity between the rear power window switch 14P connector terminals and rear power window motor 2P connector terminals as shown. There should be continuity.

CONNECTOR TERMINALS REFERENCE

Rear power window switch 14P connector	Rear power window motor 2P connector
1 (RED)	1 (RED)
2 (BRN)	2 (BRN)

Fig 4: Checking Continuity Between Rear Power Window Switch 14P Connector Terminals And Rear Power Window Motor 2P Connector Terminals

Courtesy of AMERICAN HONDA MOTOR CO., INC.

If the wire harness is OK, faulty rear power window motor; replace the rear door regulator (see REAR DOOR GLASS AND REGULATOR REPLACEMENT ).