FixVault
Home › Honda › 2007 › Element SC, Standard › Repair and Diagnosis › External Pages › Different variant/trim › Section 1 (Automatic Transmission) › Input Shaft (Mainshaft) Speed Sensor Replacement

Input Shaft (Mainshaft) Speed Sensor Replacement

WARNING: This page is about a different variant/trim than selected.
  1. Remove the air cleaner assembly (see AIR CLEANER REMOVAL/INSTALLATION ).
  2. Disconnect the input shaft (mainshaft) speed sensor connector, and remove the input shaft (mainshaft) speed sensor (A).
    Fig 1: Input Shaft Speed Sensor With Torque Specifications
    G06266901Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Install a new O-ring (B) on a new input shaft (mainshaft) speed sensor, then install the input shaft (mainshaft) speed sensor, and washer (C) in the transmission housing.
  4. Check the connector for rust, dirt, or oil, and clean or repair if necessary. Then connect the connector securely.
  5. Install the air cleaner assembly (see AIR CLEANER REMOVAL/INSTALLATION ).
About FixVault