Center Console Removal/Installation

Special Tools Required

KTC trim tool set SOJATP2014 *

* Available through the American Honda Tool and Equipment Program; call 888-424-6857

NOTE:

Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
Take care not to scratch the front seat, dashboard, and related parts.
The M/T model is shown, the A/T model is similar.

Remove the parking brake cover lid (A).

Fig 1: Identifying Parking Brake Cover Lid
M/T model: Remove the shift knob.

Fig 2: Removing Shift Knob - M/T Model
Remove the center console (A):
- Remove the screws (B), and clips (C).
- Lift the rear of the console up to detach the clip (D), and pull the console rearward to release the front hook (E) from the heater unit.
- Disconnect the accessory socket connector (F), and if equipped, auxiliary jack connector (G).
Fig 3: Removing Center Console
Install the console in the reverse order of removal, and note these items:
- Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
- Make sure the wire harness is not pinched.
- Make sure each connector is plugged in properly.
- Set the rib (H) under the pocket onto the parking brake lever bracket (I) correctly.