FixVault
Home › Honda › 2007 › Fit Base, Standard › Repair and Diagnosis › Engine Mechanical › Mechanical › Cylinder Head › Rocker Arm Assembly Installation

Rocker Arm Assembly Installation

  1. Install the rocker arm assembly (A) with dowel pin (B).
    NOTE: When reassembling the rocker arms. Install the rocker arm from cam chain side on the rocker shaft.
    Fig 1: Identifying Rocker Arm Assembly
    G05454269Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Tighten each bolts two turns at a time iii sequence below.

    Specified torque: 

    29 N.m (3.0 kgf.m, 22 lbf.ft) 

    Apply new engine oil to the bolt threads and flange 

    Fig 2: Identifying Rocker Arm Bolts In Sequence
    G05454270Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the rubber bands (A) from the intake rocker arms.
  4. Adjust the valve clearance (see VALVE CLEARANCE ADJUSTMENT ).
  5. Install the cylinder head cover (see CYLINDER HEAD COVER INSTALLATION ).
About FixVault