VVT Sensor: Installation
WARNING: This page is about a different car, the 2007 Toyota Tacoma. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL VVT SENSOR
- LH bank side VVT sensor:
- Apply a light coat of engine oil to the O-ring of the VVT sensor.
- Install the VVT sensor with the bolt.
Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
- Connect the VVT sensor connector.
- Connect the water by-pass hoses No. 4 and No. 5.
- RH bank side VVT sensor:
- Apply a light coat of engine oil to the O-ring of the VVT sensor.
- Install the VVT sensor with the bolt.
Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
- Connect the VVT sensor connector.
- LH bank side VVT sensor:
- INSTALL AIR CLEANER ASSEMBLY (See INSTALLATION )
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)
- ADD ENGINE COOLANT (See COOLANT )
- CHECK FOR ENGINE COOLANT LEAKAGE (See COOLANT )
- INSTALL V-BANK COVER
- Install the V-bank cover with the 2 nuts.
Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf)
- Install the V-bank cover with the 2 nuts.