FixVault
Home › Honda › 2007 › Pilot EX, 3.5 YF2 › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transmission › Input Shaft (Mainshaft) Speed Sensor Replacement

Input Shaft (Mainshaft) Speed Sensor Replacement

  1. Remove the splash shield.
  2. Disconnect the input shaft (mainshaft) speed sensor connector, and remove the input shaft (mainshaft) speed sensor (A).
    Fig 1: Input Shaft (Mainshaft) Speed Sensor And O-Ring With Torque Specifications
    G05593977Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Install the new O-ring (B) on the new input shaft (mainshaft) speed sensor and apply clean ATF to the O-ring, then install the input shaft (mainshaft) speed sensor in the transmission housing.
  4. Check the connector for rust, dirt, or oil, then connect the connector securely.
  5. Install the splash shield.
About FixVault