FixVault
Home › Honda › 2007 › Pilot EX, 3.5 YF2 › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transmission › Output Shaft (Countershaft) Speed Sensor Replacement

Output Shaft (Countershaft) Speed Sensor Replacement

  1. Remove the splash shield.
  2. Disconnect the output shaft (countershaft) speed sensor connector, and remove the output shaft (countershaft) speed sensor (A).
    Fig 1: Output Shaft (Countershaft) Speed Sensor And O-Ring With Torque Specifications
    G05593978Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Install the new O-ring (B) on the new output shaft (countershaft) speed sensor and apply clean ATF to the O-ring, then install the output shaft (countershaft) speed sensor in the transmission housing.
  4. Check the connector for rust, dirt, or oil, then connect the connector securely.
  5. Install the splash shield.
About FixVault