Selector Control Shaft Bearing Replacement

Special Tools Required 

• Bearing remover shaft, 10 mm 07936-GE00100
• Bearing remover head, 10 mm 07936-GE00200
• Sliding hammer weight 07741-0010201
• Driver 07749-0010000
• Attachment, 22 x 24 mm 07746-0010800

1. Remove the control shaft bearing from the transmission housing with the bearing remover head (10 mm), bearing remover shaft (10 mm), and sliding hammer weight.
   Fig 1: Removing Control Shaft Bearing From Transmission Housing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Install the new bearing until it bottoms in the transmission housing with the driver and attachment (22 x 24 mm).
   Fig 2: Installing Bearing In Transmission Housing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.