FixVault
Home › Honda › 2007 › Ridgeline RTL › Repair and Diagnosis › External Pages › Different car › Section 65 (Automatic Transmission) › ATF Temperature Sensor Replacement

ATF Temperature Sensor Replacement

WARNING: This page is about a different car, the 2008 Honda Pilot, 2007 Honda Pilot, and 2006 Honda Pilot. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the splash shield.
  2. Drain the automatic transmission fluid (ATF) (see step  3 ).
  3. Disconnect the ATF temperature sensor connector (A), then remove the connector from the connector bracket (B).
    Fig 1: Locating ATF Temperature Sensor With Torque Specifications
    G05593983Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the harness clamp (C) from its bracket (D).
  5. Remove the ATF temperature sensor (E).
  6. Install a new O-ring (F) on the new ATF temperature sensor, and install the ATF temperature sensor.
  7. Check the connector for rust, dirt, or oil. Connect the connector securely, and install it on its bracket.
  8. Install the harness clamp on its bracket.
  9. Refill the transmission with the ATF (see step  5 ).
  10. Install the splash shield.
About FixVault