FixVault
Home › Honda › 2008 › Fit Base, Standard › Repair and Diagnosis › Heating, Ventilation & A/C (HVAC) › HVAC Control Systems › Heating System › Blower Unit Removal/Installation

Blower Unit Removal/Installation

  1. Remove the dashboard (see DASHBOARD/ STEERING HANGER BEAM REMOVAL/INSTALLATION ).
  2. Disconnect the recirculation control cable from the recirculation control linkage (see RECIRCULATION CONTROL CABLE ADJUSTMENT ).
  3. Disconnect the connector (A) from the blower motor, then remove the mounting bolt, the self-tapping screws, and the bracket (B).
    Fig 1: Blower Unit Connector And Bracket With Torque Specification
    G05456447Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the clip (A). Remove the mounting bolt, the screws, and the bracket (B). Remove the connector clip (C). Remove the self-tapping screws and the blower unit (D).
    Fig 2: Clip, Bracket And Blower Unit With Torque Specification
    G05456448Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Install the blower unit in the reverse order of removal. Make sure that there is no air leakage.
About FixVault