Oil Pan Installation

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Honda Odyssey, 2016 Honda Odyssey, 2015 Honda Odyssey, 2014 Honda Odyssey, and 2013 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.

Remove all of the old liquid gasket from the oil pan mating surfaces, the bolts, and the bolt holes.
Clean and dry the oil pan mating surfaces.
Apply liquid gasket (P/N 08717-0004, 08718-0003, 08718-0004, or 08718-0009) to the oil pan mating surface of the engine block and to the inside edge of the threaded bolt holes. Install the component within 5 minutes of applying the liquid gasket.
NOTE:
- Apply a 2.5 mm (0.098 in) diameter bead of liquid gasket along the broken line (A).
- If you apply liquid gasket P/N 08718-0012, the component must be installed within 4 minutes.
- If too much time has passed after applying the liquid gasket, remove the old liquid gasket and residue, then reapply the new liquid gasket.
  
  Fig 1: Identifying Liquid Gasket Applying Area
  Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the oil pan on the engine block.
Tighten the bolts in three steps. In the final step, torque the bolts, in sequence, to 12 N.m (1.2 kgf.m, 9 lbf.ft).
NOTE:
- Wait at least 30 minutes before filling the engine with oil.
- Do not run the engine for at least 3 hours after installing the oil pan.
  
  Fig 2: Identifying Oil Pan Mounting Bolts Tightening Sequence
  Courtesy of AMERICAN HONDA MOTOR CO., INC.
Tighten the four bolts (A) securing the transmission, then install the torque converter case cover (B).

Fig 3: Torque Converter Case Cover With Transmission Mounting Bolts Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Connect the CKP sensor connector (A), then install the CKP sensor cover (B) and the bolt (C).

Fig 4: CKP Sensor Connector, CKP Sensor Cover With Mounting Bolt Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the rear warm up TWC bracket.

Fig 5: Rear Warm Up TWC Bracket With Mounting Bolts Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the engine is still in the vehicle, do the following steps.
Install exhaust pipe A using new gaskets and new self-locking nuts (see step 30 in ENGINE INSTALLATION ).
Install the splash shield (see FRONT SPLASH SHIELD REPLACEMENT ).
Refill the engine with engine oil (see ENGINE OIL REPLACEMENT ).