Injector Base Removal and Installation: Installation

Install the front injector base (A) and the rear injector base (B) with new gaskets (C), and tighten the injector base mounting bolts/nuts (D) in a crisscross pattern in three steps, beginning with the inner nuts.
NOTE: The front injector base gasket is different from the rear one. Do not mix injector base gasket types.

Fig 1: Front Injector Base And Rear Injector Base With Gaskets With Torque Specification
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Connect the knock sensor connector (A), then install the harness holder mounting bolt (B).

Fig 2: Knock Sensor Connector With Harness Holder Mounting Bolt With Torque Specification
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the injectors (see INJECTOR REPLACEMENT ).
Install the intake manifold (see INSTALLATION ).
Install the P/S pump and P/S hose bracket:
- J35A6 engine (see step 31 on CAMSHAFT OIL SEAL INSTALLATION - IN CAR )
- '07 model J35A7 engine (see step 30 on CAMSHAFT OIL SEAL INSTALLATION - IN CAR )
- '08-09 models J35A7 engine (see step 27 on CAMSHAFT OIL SEAL INSTALLATION - IN CAR )
Inspect for fuel leaks. Turn the ignition switch to ON (II) (do not operate the starter) so the fuel pump runs for about 2 seconds and pressurizes the fuel line. Repeat this operation three times, then check for fuel leakage at any point in the fuel line.